3/31/2024 0 Comments 2012 f150 xlt stereo upgradeF150 stereo upgrade gives supercrew some super sounds. I bought KnuKonceptz connectors with the screw set. How to install 2012 2013 ford f150 car stereo with bluetooth mirrorGen ii t style radio for 2015-19 ford f-series adc mobile 2017 f150 xlt stereo upgradeXlt supercrew 2wd. couldnt find my heat gun so I used the toaster over. I cut a piece off to run to battery to the inline fuse all purty like. What is the reason for this Is there no room behind the 4in display for a full double din head unit the attahced looks promising, but hesitant wothout any reviews. Very disapppointed that no dash kit exists. Ill probably trim some more off after when I decide where the amp lands. Have been looking forward to purchasing a Pioneer NEX for CarPlay. And even after I ran the cable all the to the drivers side of the back and left a little slack I cut it and had 5 feet left. It was a 20 foot cable ( I bought a 20 so I would enough left over for a ground wire). I couldnt find it on the inside but then my 15 year old reached up and found it first try! I proceeded to run it down the passenger side in the well underneath the coversthen behind the carpet along the back behind the back seats. I used a fish tape from outside the truck into the cab. it's hot out there!įord gave us a PERFECT place to run the wire right behind the battery on the firewall with a perfectly places and sized grommet (it will fit 0 gauge for sure too). I absolutely will be changing them in phase 2. I am not changing the stock speakers in the first phase. I am using a Alpine S-W10D4 subwoofer wired to 2OHMĦ. I believe these two companies make an INCREDIBLE product that truly sound amazing, even in their lower-end offerings. I have a Fox Acoustics ported 10" Fox Boxĥ. When it comes to speakers, I have always been a JL Audio fan, with Focal in a close 2nd place. I am re-using my Pioneer D9605 amplifier that I had in my last truck (07 Chevy Avalanche) - it's a 5 channel amp with 75x4 (4OHM) and 600x1 (2OHM).Ĥ. I am using HUSH AUDIO CK11 pre-built harness (recommended as it looks freaking clean as hell!)ģ. I have a pretty clear plan, I am just documenting it because you never know if it will help someone else.ġ. First, I am not looking for advice but its always welcome.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |